Search by Keyword, Part Number, SKU, UPC
A master adapter must always be installed, but the two slave adapters are optional and may be installed on an as needed basis. Connect the power supply to the adapter.Wire tie the power supply cord to the connector if desired. Connect the module to the adapter and slide the power supply cord below the module. Insert the two screws supplied with the module through the module screw holes and then through the two washers, with the larger washer first and the smaller retaining washer second. Then, insert the module and adapter into the module bay by sliding them along the card guides inside the module bays. Secure them to the chassis using the two screws. A gap between the unit’s back panel and the module will exist to allow the power supply wire to exit.
MA3 Installation Manual